Toll Free Phone: 800-627-0266        Phone: 979-282-2861

Dorian Tool International Incorporated

Turning & Grooving Method - Steps

Step 1.

Starting Groove

Set the toolholder close to
the starting point of the groove

Cut the first groove to depth of the first roughing cutting diameter

 


 

Step 2.

Multi Turning Roughing Cut

Once the first groove is cut, feed the insert toward the other side of the workpiece. Cut till the end is reached then retract the toolholder at 45° away from the wall.


 

Step3.

Multi Turning Roughing Cut

After the first roughing cut, repeat the operation from side to side until the roughing operation is complete


 

Step 4.

First Finishing Cut

Face-off at finish dimension one side of the groove to the finished diameter, then retract the toolholder
at 45° away from the wall.


 

Step 5.

Final Finishing Cut

Move the toolholder on the other side of the wall of the groove, face-off to the finished diameter and continue to cut the entire surface till the other wall is reached,then retract the toolholder at 45° away from the wall.
Note: The Grooving and Turning
Method, is slower than the Grooving and Turning Method, however the insert is fully utilized on all the 3 sides.

Translate »